Pow/Aux (Power Supply For Smartwire-Dt) - Eaton XV-102 Operating Instructions Manual

5.3.8.3
Wiring

POW/AUX (power supply for SmartWire-DT)

The POW/AUX interface is not electrically isolated.
The following supply voltages are required in a SmartWire-DT netwerk:
Supply voltage POW:
The device supply voltage for the electronics of the downstream SmartWire-DT slaves (15 VDC)
is generated from the 24 VDC supply voltage applied to the POW connection.
Supply voltage AUX:
If there are any contactors or motor starters in the SmartWire-DT topology, a 24 VDC voltage AUX
must be additionally supplied as a control voltage for the contactor coils.
For other power supply requirements see Chapter 9.5.2 SmartWire-DT Master,
Fig. 17 Power supply interface POW/AUX
WAGO connector, order no. 734-104 is supplied with the device.
Fig. 18 WAGO connector (view from the wiring side)
Connection
+24 VDC POW Supply voltage U
0 V POW Supply voltage U
+24 VDC AUX
0 V AUX
Tab. 13 Assignment of connector
The following must be observed when the connector wiring is prepared:
Preparing the wiring of the connector
Terminal type
Crimpable wire solid
Stripping length
Tab. 14 Preparing the wiring of the connector
XV-102 Micro Panel MN04802004Z-EN—February 2013 www.eaton.com
www.comoso.com
+24 VDC POW
0 V POW
+24 VDC AUX
0 V AUX
Assignment
+24 VDC
Pow
0 V
Pow
Supply voltage U +24 VDC
Aux
Supply voltage U 0 V
Aux
Tension clamp terminal
2
0.2...1.5 mm (AWG24...16)
6...7 mm
5 Installation
5.3 Interfaces
70.
35