Appendix A: Network Points List for RTU Open
Third party access to BACnet points in a controller
BACnet system points in the i-Vu® Open controllers match physical I/O points to data, such as Outside Air Temp,
to be written to the controller through the network, rather than by using a local hardwired sensor.
When a BACnet system point is written to, the controller uses the network value, even when there is a local
sensor, as long as it is within the Min/Max refresh times noted below.
BACnet writes to system points
The following table lists all of the writeable system points that could be present in an i-Vu® Open controller. The
list of points is application-specific, therefore not all points are present in all i-Vu® Open controllers. This
information applies whether the system point is being accessed by another i-Vu® Open controller or by a third
party system.
RTU Open v5
Integration Guide
Appendix A: Network Points List for RTU Open
41
CARRIER CORPORATION ©2019
All rights reserved