Starting The Brew; Enter Programming; Exit Programming & Save - Fetco EXTRACTOR V+ CBS-1150 User’s Manual & Operator Instructions

1. Turn the power switch "ON".
READY READY
2. Prepare a brew basket with the correct size filter and appropriate amount of coffee.
3. Slide the brew basket completely into the rails.
4. Place a clean, empty, preheated dispenser under the brew basket.
5. Select a batch & hold the corresponding BREW button in for 1 second to start
STOP STOP
6. -STOP button will illuminate,
-Countdown time will display,
-Selected BREW button will flash to indicate brew is in progress.
-All other BREW buttons for that brew head will extinguish.
7. When the brew cycle is finished,
STOP button will extinguish and the BREW button will continue to flash for the amount
of time programmed into the DRIP DELAY setting.
This indicates that coffee may still be dripping from the brew basket
For safety- do not remove brew basket until drip-out is complete.
Twin Brewer ready to brew. Pressing top right brew position
Screens shown are for twin brewer. Single brewer will not have menu A4-A6.
There are five menu groups-A-E . See the following pages for the batch parameter definitions and all settings for the brewer
TO ENTER PROGAMMING
1-Turn brewer "OFF" from power switch
2-Turn power switch to "ON"
...Screen will initialize and then
display digital process notifications
3-After iitailization-Red "STOP" Lamp turns on
4-Quickly hold down "STOP" button for 5 seconds
When brewer is In PROGRAMMING MODE
-the screen will display:
|BATCH PRG|
|A (or B-E) |
-
Illuminated LED indicates active keypad positions
See the following pages for batch parameter
definitions and all settings for the brewer
Programming A-F
A - F
STOP
STOP
1
2
3
From any screen-
Press STOP button
until the EXIT ("F")
screen appears
Go to fetco.com for the latest versions of all information

Starting The Brew

Enter Programming

STOP BUTTON
↓
Exit Programming & Save Control Setting Changes
EXIT
F NO +
STOP STOP
1
2
3
From the "F" screen
Press button 2 to
toggle to the EXIT-
YES screen
STOP
ON/OFF switch
is located on
lower right on
Turn power OFF
back of brewer
Turn power ON
Wait for red LED
And quickly hold down
STOP button on front
touch panel for 5 sec.
EXIT
F YES -
STOP STOP
1
2
3
From EXIT screen From SAVE screen
Press button 1 to
toggle to the SAVE toggle to the SAVE-
screen
Page 4
Brewing-see #6 above
Batch PRG
LOADING
A
STOP
STOP
First screen will display
for PROGAMMING-A
Scroll through main menu
topics by pressing
"STOP" button.
SAVE
SAVE
F NO + F
STOP STOP
1
2
3
To SAVE and EXIT
Press button 2 to Press button 1 to
SAVE your changes
YES screen
P167 November 2017
READY BREW
05:30
STOP STOP
STOP
YES -
STOP STOP
1
2
3
and EXIT