Access Point Address
Scan the barcode below to determine the address of the Access Point you are
using.
Paging
Page Mode
By default, the paging button on the Access Point pages the scanners associated
with that Access Point. If you want the paging button on your Access Point to be
disabled, scan the Page Mode Off barcode, below. When Page Mode is off, the
Access Point will no longer page scanners when the button is pressed. The blue
LED on the Access Point will remain lit to indicate that PageMode is off. (This light
will go out when the button is pressed, then back on when it's released.) Default =
Page Mode On.
Paging
Pitch
When you press the Page button on the Access Point, the scanners associated with
that Access Point will begin beeping. You can set the pitch of the paging beep for
each scanner by scanning one of the following barcodes. Default = Low.
Voyager 1602g User Guide
* Page Mode On
* Low (1000 Hz)
Base Address
Page Mode Off
Medium (3250 Hz)
57