Printer Components: Front Cover To Usb Port - Fargo DTC300 User Manual

RESTRICTED USE ONLY

Printer Components: Front Cover to USB Port

Components Description
Opens to allow access to the Ribbon Cartridge. (Note: This cover must
Front Cover
be closed in order for the Printer to begin printing.)
Printhead The component of the Printer that actually does the printing. (Note: This
component is fragile and must not be bumped or touched with anything
other than a cleaning swab.)
Cancel button The Cancel button
serves to cancel the current print job and reset the Printer for the next
print job.)
If a card is left within the Printer after a print job is canceled, it will
automatically be ejected when the Printer is turned back ON.
Pause button The Pause button is used to pause the Printer during normal operation
and also to resume operation after an error condition is cleared. (Note:
In general, as the icon above this button indicates, errors are related to
either the Ribbon or the cards. If an error occurs, the Pause LED will
flash.)
Automatically cleans cards for higher print quality. (Note: Clean the
Card
Cleaning Card Cleaning Roller during every Ribbon change, as needed.)
Roller
Card Input Load blank cards into this Hopper.
Hopper
Flipper Cover Opens to allow access to the Card Flipper.
E-Card Ports Connects to the Printer's E-Card Stations.
Power Port Connect to the included power cord.
USB Port Connect to a Windows PC with a USB cable.
DTC300/DTC300M Card Printer/Encoder User Guide (Rev. 2.2)
turns the Printer ON and OFF. (Note: It also
Fargo Electronics, Inc.
2-8