Using The Print End Of Form Option; Card Output; Card Input - Fargo DTC300 User Manual

RESTRICTED USE ONLY

Using the Print End of Form Option

Use this option to reduce or increase the overall printable area in order to optimize edge-to-
edge printing toward the trailing edge of a card. (Note: When adjusting this value, keep in
mind that cards always remain in the same position while moving through the Printer.)
The diagram (below) represents how the end of form will move in relation to the fixed card
position as a positive or negative Print End of Form value is entered.
Step Procedure
1 Enter a negative value to reduce the Print End of Form and move the end of the
printable area more toward the leading edge of the card.
OR
Enter a positive value to increase the print length and move the end of the
printable area more toward the trailing edge of the card.
Maximum Adjustment Range: The maximum adjustment range is ±127. As a

rule, 10 equals about .030"/. 8mm, which is about the same as the thickness of
a standard CR-80 size card.)

Card Output

Side of Printer
(Leading Edge
of Card)
DTC300/DTC300M Card Printer/Encoder User Guide (Rev. 2.2)
Rear of Printer
Direction card travels through printer
Front of Printer
Fargo Electronics, Inc.
-

Card Input

Side of Printer
(Trailing Edge
of Card)
5-96