Port Commands - Extreme Networks BlackDiamond 6800 User Manual

Table 3-1: Port Commands
Command
enable learning port <slot:portlist>
enable port <slot:portlist>
enable sharing <slot:master_port> grouping
<slot:portlist>
config port <slot:portlist> auto on
config port [<slot:portlist> | all] auto off
{speed [10 | 100]} duplex [half | full]
config port <slot:portlist> qosprofile
<qosname>
config slot <slot> module [f32t | f32f | g4x |
g6x]
disable learning port <slot:portlist>
disable port <slot:portlist>
disable sharing <slot:master_port>
clear slot <slot> module
show port {<slot:portlist>} collisions
B D U G
LACK IAMOND SER UIDE
Description
Enables MAC address learning on one or more
ports. The default setting is enabled.
Enables a port.
Defines a load-sharing group of ports. The ports
specified in <slot:portlist> are grouped to
the master port.
Enables autonegotiation for the particular port
type; 802.3u for 10/100 Mbps ports or 802.3z for
Gigabit Ethernet ports.
Changes the configuration of a group of ports.
Specify the following:
auto off — The port will not autonegotiate
the settings
speed — The speed of the port (for 10/100
Mbps ports only)
duplex — The duplex setting (half- or
full-duplex)
Configures one or more ports to use a particular
QoS profile.
Configures a slot for a particular I/O module card.
Disables MAC address learning on one or more
ports for security purposes. If MAC address
learning is disabled, only broadcast traffic and
packets destined to a permanent MAC address
matching that port number are forwarded. The
default setting is enabled.
Disables a port. Even when disabled, the link is
available for diagnostic purposes.
Disables a load-sharing group of ports.
Clears a slot of a previously assigned module
type.
Displays real-time collision statistics.
P C
ORT OMMANDS
3-5