Status Messages; Saving Changes; Standalone Buttons - Extreme Networks BlackDiamond 6800 User Manual

Table 12-1: Multi-Select List Box Key Definitions (continued)
Selection Type
Contiguous items
Selected non-contiguous items
S M
TATUS
Status messages are displayed at the top of the content frame. There are four types of
status messages, as follows:
• Information—Displays information that is useful to know prior to, or as a result of,
changing configuration options.
• Warning—Displays warnings about the switch configuration.
• Error—Displays errors caused by incorrectly configured settings.
• Success—Displays informational messages after you click Submit. The message
displayed reads, "Request was submitted successfully."
S
TANDALONE
At the bottom of some of the content frames is a section that contains standalone
buttons. Standalone buttons are used to perform tasks that are not associated with a
particular configuration option. An example of this is the Reboot Switch button.
S
AVING
There are two ways to save your changes to non-volatile RAM (NVRAM) storage using
ExtremeWare Vista:
• Select Save Configuration from the Configuration task button, Switch option.
This field contains a drop-down list box that allows you to select either the primary
or secondary configuration area. After you select the configuration area, click Submit
to save the changes.
For more information on the primary and secondary configuration areas, refer to
Chapter
B D U G
LACK IAMOND SER UIDE
ESSAGES
B
UTTONS
C
HANGES
13.
Key Sequence
Click the first desired item, and
drag to the last desired item.
Hold down [Control], click the first
desired item, click the next desired
item, and so on.
S C
AVING HANGES
12-5