Extreme Networks BlackDiamond 6800 User Manual page 124

IP U R
NICAST OUTING
Table 8-2: Basic IP Commands (continued)
Command
clear ipfdb [<ipaddress> | vlan <name> | all]
enable esrp port <slot:portlist>
config port <slot:portlist> esrp group <number>
config port <slot:portlist> esrp priority <value>
config port <slot:portlist> esrp timer <hello_value>
disable esrp port <slot:portlist>
Table 8-3 describes the commands used to configure the IP route table.
Table 8-3: Route Table Configuration Commands
Command
enable iproute sharing
config ipqos add <ip_destination_address>
<mask> qosprofile <qosname>
config ipqos delete <ip_destination_address>
<mask>
config iproute add <ipaddress> <mask>
<gateway> <metric>
config iproute delete <ipaddress> <mask>
<gateway>
config iproute add blackhole <ipaddress>
<mask>
config iproute delete blackhole <ipaddress>
<mask>
8-14
Description
Removes the dynamic entries in the IP
forwarding database.
Enables ESRP on a port.
Assigns a port to an ESRP group. The
valid group numbers are from 1 to 32.
Configures the virtual router priority. The
range is 1to 32.
Configures the virtual router keep-alive
timer. The range is 1 to 255.
Disables ESRP on a port.
Description
Enables load sharing if multiple routes to the
same destination are available. Only paths with
the same lowest cost are shared. The default
setting is enabled.
Adds a QoS profile to an IP destination
address.
Deletes a QoS profile from an IP destination
address.
Adds a static address to the routing table. Use
a value of 255.255.255.255 for mask to
indicate a host entry
Deletes a static address from the routing table.
Adds a blackhole address to the routing
table. All traffic destined for the configured IP
address is dropped, and no Internet Control
Message Protocol (ICMP) message is
generated.
Deletes a blackhole address from the routing
table.
B D U G
LACK IAMOND SER UIDE