Configuration Example - Extreme Networks BlackDiamond 6800 User Manual

Table 10-2: IGMP Configuration Commands (continued)
Command
config igmp snooping <router_timeout>
<host_timeout>
C
ONFIGURATION
Figure 10-1 is used in
Refer to Chapter 9
system labeled IR1 is configured for IP multicast routing.
B D U G
LACK IAMOND SER UIDE
E
XAMPLE
Chapter 9 to describe the OSPF configuration on a BlackDiamond.
for more information about configuring OSPF. In this example, the
Description
Configures the IGMP snooping timers. Timers
should be set to approximately 2.5 times the
router query interval in use on the network.
Specify the following:
router_timeout — The interval, in
seconds, between the last time the router was
discovered and the current time. The range is
10 to 4,294,967,296 seconds (136 years). The
default setting is 260 seconds.
host_timeout — The interval, in seconds,
between the last IGMP group report message
from the host and the current time. The range
is 10 to 4,294,967,296 seconds (136 years).
The default setting is 260 seconds.
C E
ONFIGURATION XAMPLE
10-5