Installation And Start-Up - Care of Sweden CuroCell S.A.M. PRO User Manual

Constant low pressure reactive air mattress system
Hide thumbs Also See for CuroCell S.A.M. PRO:
Table of Contents

Advertisement

3. Installation and start-up

3.1 Installation
When unpacking, check that no parts are damaged. If any damage is found, contact Care of
Sweden or your local distributor before using the product.
1a. If the mattress is an overlay mattress, place the mattress on top of an existing mattress. If
possible, secure it by pulling the elastic bands on the bottom over the corners of the
underlying mattress.
or
1b. If the mattress is a replacement mattress and have an integrated foam core
S.A.M.® PRO CF16),
to fasten the mattress to the bed base.
2. Hang the pump by the foot end of the bed or place it on a flat, sturdy surface. Place the
power cable so there is no risk of stumbling over it, run it over with the bed wheels or getting
it jammed when raising or lowering the bed.
3. Connect the air tubes coming from the mattress to the side of the pump. The pump and
hoses are equipped with quick connectors; an audible "click" will be heard when these have
been connected correctly.
4. Check to make sure that the power is set to "0" (off). Plug the power cable into an
approved outlet (110 or 220 V depending on the country and the voltage level).
NOTE:
• Make the bed with sheets to increase user comfort.
• Check that the CPR valve is closed.
• Make sure that the mattress is the correct size for the bed.
3.2 Start-up and settings
NOTE:
Always read the instructions for use prior to use.
1. Start the pump by pressing "1" (on), on the side of the pump.
2. The pump starts filling the mattress with air. The green light with the
during the inflation phase; it takes about 15 minutes for the mattress to fill with air.
3. When the
symbol shows a steady green light, the mattress is ready to be used.
3.3 Comfort settings
The air pressure in the mattress can be adjusted according to the user's comfort preference.
Always consult the prescriber or other authorised personnel for the appropriate setting.
Appropriate air pressure is selected using the knob (0–250 kg). The numbered scale guides
your selection. For sitting positions, we recommend that the pressure be raised by +25
Check using the hand check (see section 3.4).
place the mattress directly on to the bed base.
9
(CuroCell
Use the straps on the
symbol will flash
cover
kg.

Advertisement

Table of Contents
loading

Table of Contents