Assembly/Installation - Care of Sweden CuroCell 4 User Manual

3. Assembly/Installation

When unpacking the mattress, check that none of the parts are damaged. In the event of
damage, contact the manufacturer or your local dealer before using the product.
1. Place the mattress on the bed base; use the straps on
the cover to securely fasten the mattress to the bed
base.
Note!
• Make the bed with sheets for added comfort.
• Check that the CPR valve/valves are properly closed.
• If the bed is height adjustable, the mattress must only
be attached to the bed's moving parts.
• Check the cells and snaps to make sure that they have
been attached correctly.
2. Hang the pump at the foot end of the bed or place it on a
flat, steady surface.
Route the power cord so that there is no risk of it causing
someone to trip, being run over by the bed wheels or
getting pinched when the bed is raised or lowered.
If a cable holder is used (optional): open the snaps,
position the power cord in the pocket and close the
snaps.
Note! In order to minimize the risk of wounds occurring
on the feet, make sure that the user doesn't come into
contact with the hangers of the pump.
3. Connect the air tubes from the mattress to the side of
the pump. There is an audible "click" sound when the
connectors are properly attached.
4. Check that the power switch on the side is set to 0 (OFF).
Connect the plug to an approved electrical socket (220
V).
8