Assembly/Installation - Care of Sweden CuroCell AUTO4 User Manual

3. Assembly/Installation

When unpacking, check that no parts are damaged. If any damage is found, contact Care of
Sweden before using the product.
1. If the mattress has an integrated foam cushion
AUTO4) then the mattress is placed directly on the bed
base. Secure the mattress to the moving parts of the bed
using the straps on the cover.
In the case of CuroCell®
the existing mattress and secure the elastic straps
the underlying mattress.
Note:
• Make up the bed with a sheet to improve user comfort.
• Check that the CPR valve is closed.
• If an adjustable bed is used, the mattress should be
secured only to the moving parts of the bed.
• Check the cells and push-buttons to ensure they are
correctly assembled.
2. Hang the pump on the foot end of the bed or place the
pump on a firm, level surface.
Place the power cord so there is no risk of tripping over it,
running over it with the bed wheels or pinching it when
raising or lowering the bed.
If a cable holder is used (optional): open the fasteners,
insert the power cord and close the fasteners.
Note! In order to minimize the risk of wounds occurring on
the feet, make sure that the user doesn't come into contact
with the hangers of the pump.
3. Connect the air tubes from the mattress to the side of the
pump. A click is heard or felt when they are correctly
connected.
4. Check that the power switch on the side is set to 0 (off).
Plug the power cord into an approved socket (220 V).
For 80/85/90x200/210
8
AUTO4 CX, place the mattress on
For 105/120x200/210
(CuroCell®
around