Base Heater Kit (Cw-H-E) - Mitsubishi Electric FDF100VSXVD Technical Manual

INSTALLATION MANUAL FOR
(3) Base heater kit (CW-H-E1)
BASE HEATER KIT
Follow the instruction and installation manual for outdoor unit when
installing the heater.
This heater must be installed by authorized personnel.
Turn off the power supply when the kit is installed.
Failure to follow the above will result in serious accident like electrical
shock or fire.
AREAS TO BE APPLIED
This kit is to be used in an area where the lowest temperature drops below
zero.
Caution: In case the heater is not applied on the unit which is installed in an
area mentioned above, it may be regarded as installation failure
and warranty may not be given.
Components
Heater
Bracket
Tapping screw
Plastic band with clip : 2pcs
Plastic band
Installation procedure
Step 1
1. Remove the top panel of the outdoor unit
(11 pcs of tapping screws).
Step 2
2. Remove the service panel
(4 pcs of tapping screws).
WARNING
: 1pc
: 4pcs
: 4pcs
: 5pcs
Follow the law or regulation of the country where it is installed.
Do not alter the heater.
Lay down the heater so that the edge of the sheet metal does not
damage the heater.
Bending radius must be bigger than 25mm.
Do not use the heater near flammable substances.
Be sure to check the electrical insulation before use.
Be sure to check the drain is not trapped by the heater.
Do not leave refrigerant oil on the base.
Heater
- 205 -
'11 • PAC-T-160
Model Name: CW-H-E
Parts Number: 518325
CAUTION
Bracket Tapping screw
Plastic band with clip
Plastic band without clip
PCZ012D007