Microcom 334M Operator's Manual page 86

Chapter 5
>UNDER VDD<
>OVER TEMP<
>DATA ERROR<
>STOCK NOT LOADED<
>BUTTON PRESSED<
>LPD STOCK JAM<
>BROWNOUT RECOVERY<
>FAIL TIMEOUT<
>FAIL SIZE<
>NO FLASH DATA FOUND<
>CHECKSUM
VERIFICATION FAILED<
>FLASH READBACK
FAILED<
>ERASE FAILED FOR
SECTOR n<
Table . Each string is represented by a single byte with nothing separating them. The end
of the response is terminated with a 0xFF character.
334M Operator's Manual - 880060-0110
1C VDD voltage is out of operational range
1D
15
22 Printer power on without media installed.
Print button configured to report message
C0
Reports when jams are detected. Switch 8
11
position 8 enables this feature
Printer entered and recovered from a
brownout power condition
Timeout failure occurred using the D149
Incorrect size of the image was received
using the D149 Image Print Mode
The printer was unable to locate a valid
configuration and is forcing the default
configuration or "birth" pattern.
Configuration checksum does not match
printer will attempt to restore configuration.
The printer failed to read and verify the
configuration parameters are present.
The flash was unable to erase at the
memory sector noted by the "n"
Printer Commands
Print Head is too hot
Communication error
when pressed.
Image Print Mode
5-4