Attaching To Standardized Vesa Support Arm At The Vep 30.6 - Bosch rexroth IndraControl VEP 30.6 Operating Instructions Manual

28/49
Mounting, demounting and electric installation
4. Plug the cable grommet into the housing.
5. Provide the cables, which are lead through a cable grommet, with a strain
relief.
6. Cover not used openings with a dummy sleeve.
7. Check that the seal of the cover is not damaged.
8. Position the cover properly and fasten the screws with the corresponding
tightening torque (refer to
Cable grommet name
(Assembling kit/putty)
QT4
QT5
QT6
QT7
QT8
QT11
QT12
QTB
Tab. 10-4: Cable diameter and corresponding cable grommets

10.4.2 Attaching to standardized VESA support arm at the VEP 30.6

Observe the minimum bending radius of the cables used.
Use appropriate cable material (sufficient bending and torsional
strength).
Bosch Rexroth AG R911403058_Edition 01
IndraControl VEP 30.6, VEP 40.6,
VEP 50.6 Embedded Terminals
tab. 10-3 "Tightening torques" on page
Cable diameter
4-5 mm
5-6 mm
6-7 mm
7-8 mm
8-9 mm
11-12 mm
12-13 mm
Dummy sleeve
23).