Table of Contents
Advertisement
IndraControl VEP 30.6, VEP 40.6,
VEP 50.6 Embedded Terminals
10.4 Installing the embedded terminal VEP 30.6DPN
10.4.1 Mounting the VEP 30.6DPN...
NOTICE
Use a cable grommet that fits the cable diameter. Mount the cable grommet
properly.
NOTICE
Ensure that the sealing of the cover is not damaged. Mount the cover properly.
Tighten the screws with the correct tightening torque (refer to
ening torques" on page
The connections are located below the housing cover.
1. Demount the cover by loosening the screws (see the following figure).
①
Openings for cable grommets
Fig. 10-7: Demount the cover
2. Select the corresponding cable grommet from the table (see
ble diameter and corresponding cable grommets" on page
The cable grommets and the plug to connect the keypad are in the deliv-
ered accessories kit.
3. Lay the cable grommet around the cable.
Mounting, demounting and electric installation
Loss of IP degree of protection due to wrong
size or wrong mounting of the cable grommet.
Loss of IP degree of protection due to damaged
or wrongly mounted or not sufficiently fastened
covers.
23).
1
R911403058_Edition 01 Bosch Rexroth AG
27/49
tab. 10-3 "Tight-
tab. 10-4 "Ca-
28).
Advertisement
Table of Contents
