Table of Contents
Advertisement
38/49
Maintenance
13 Error causes and troubleshooting
For information on the error display on the front panel, refer to
"Operating display" on page
Errors
No image visible
The USB flash drive does not work, al-
though other USB devices work
Limited operability of the operator display
Reduced performance
Tab. 13-1: Error causes and troubleshooting
14 Maintenance
Repairs at the device by the customer are not permitted. Exceptions
are maintenance works listed in the chapter "Maintenance".
For further information in the event of repair, please contact the
Bosch Rexroth Service.
NOTICE
Ensure that the IP degree of protection remains unchanged during maintenance!
14.1 Display
The backlight is subject to wear, see
A fading backlight causes a progressive deterioration display readability. Thus, a
replacement is necessary. For further information, please contact the Bosch
Rexroth Service.
Bosch Rexroth AG R911403058_Edition 01
36.
Troubleshooting
Connect the supply voltage and check the XD1 con-
●
nection.
Plug in CFAST card correctly.
●
Use fitting CFAST card.
●
Use USB stick formatted with FAT16 or FAT32.
●
Avoid strong high-frequency interferences close to the
●
operator display.
Ensure that the load of the CFAST cards does not exceed
70%.
Loss of IP degree of protection due to incorrect
maintenance.
chapter 5.5 "Wear parts" on page
IndraControl VEP 30.6, VEP 40.6,
VEP 50.6 Embedded Terminals
chapter 12.3
7.
Advertisement
Table of Contents
