Table of Contents
Advertisement
IndraControl VEP 30.6, VEP 40.6,
VEP 50.6 Embedded Terminals
NOTICE
In case of non-compliance with this safety instruction, material damage can
occur.
3.3 Symbols used
Pointers are displayed as follows:
This is a note.
Tips are displayed as follows:
This is a tip.
3.4 Explaining the signal alert symbol on the device
krax
4 Intended use
The Embedded Terminals of Bosch Rexroth are PC-based operator terminals de-
signed for industrial environments.
NOTICE
The Embedded Terminals may be used only as intended and with the accesso-
ries, mounting parts, and other components specified in this documentation.
Components that are not expressly mentioned must neither be attached nor
connected. The same applies to cables and lines.
Only to be operated with the component configurations and combinations ex-
pressly defined and with the software and firmware specified in the correspond-
ing functional description.
Typical areas of application of the operator display:
Handling and assembly systems
●
If this symbol is on your device, you have to observe the documentation
on the device. The respective documentation informs on the type of
hazard as well as the steps required to avoid this hazard.
Risk of damaging the device if not expressly sta-
ted accessories, mounting parts and other com-
ponents, cables, lines, software and firmware
are used.
R911403058_Edition 01 Bosch Rexroth AG
5/49
Intended use
Advertisement
Table of Contents
