Table of Contents
Advertisement
34/49
Commissioning
NOTICE
For terminal connectors use copper wire only. Tighten the screws of the screw
terminals with a torque of 2.25 lb in (0.25 Nm).
Connector X2, X3
The plugs X2 and X3 are located behind the housing cover (refer to the following
figure).
Fig. 10-13: Position of X2, X3 connectors
11 Commissioning
The product can be used directly. No configuration is required.
The "touch calibration" and the "Rexroth settings" are described in the project
planning manual "Rexroth IndraControl V Devices Operating Systems" (see
ter 1.4 "Related documents" on page
tings are already done ex works.
Bosch Rexroth AG R911403058_Edition 01
Destruction of screw terminals, insufficient con-
tact and loss of UL/CSA certificiation if no cop-
per wire is used and/or wrong tightening tor-
que.
PIN 1
X2
X3
2). For newly delivered devices, these set-
IndraControl VEP 30.6, VEP 40.6,
VEP 50.6 Embedded Terminals
chap-
Advertisement
Table of Contents
