Sharpening The Drill Bit - Drill Master X2 User Manual

Sharpening the Bit
Before sharpening you should know:
Keep the Cam in contact with the Cam Pin as you sharpen.
•
Only light pressure is required.
•
• You will hear a grinding noise
each half-turn.
• The Chuck will rock as you rotate it and the Cam rides on the
Guide.
www.drilldoctor.com
Set depth of bit and
tighten Chuck.
White
Triangle
4. With the machine turned off, align
the White Triangle on the Chuck with
Cam Pin
the Cam Pin. Insert the Chuck into
Sharpening
the Sharpening Port. Push the Chuck
Port
all the way into the Port. Tighten
the Chuck Knob while it's still in the
Sharpening Port. Remove the Chuck
and make sure the Alignment Fingers
are tightly up against the Leading
Edge of the flute. The bit should not
move in the Chuck. Your depth is now
set and you are ready to sharpen.
Insert Chuck.
5. Flip Switch to High speed (II). Align
either of the Sharpening Guides
(white lines) on the Chuck with the
Cam Pin and insert the Chuck in the
Sharpening Port.
z
z z
zz zz
z) as you complete
(z
Sharpening
Guide
Cam Pin
15