Sharpening The Drill Bit - Drill Master 500x User Manual

3.
4.
5.

Sharpening the Drill Bit

Before sharpening you should know:
• Keep the Cam in contact with the Cam Guide as you
sharpen—push the Chuck straight into the Port.
• Only light pressure is required.
14
Adjust Bit Position
Look at your bit and make
sure the Bit Clamp Arms are
in the bit's narrowest spot. If
not, turn the bit in the chuck
so that it is held by the Bit
Clamp Arms at the narrowest
width. This is important
because this setting deter-
mines the angle at which your
bit will be sharpened.
Drill Bit Stop
Bit Clamp Arms
Tighten Chuck
Hold onto the Chuck and
tighten the Chuck Knob.
(Avoid over-tightening the
Chuck in the Alignment Port;
this could damage the Chuck
and Port.)
Remove and re-tighten
Press the Alignment Button
and remove the chucked drill
bit. Tighten the Chuck once
more to ensure the bit won't
move when you sharpen it.
You are now ready to sharpen
the drill bit.
www.drilldoctor.com