Table of Contents
Advertisement
1.
Insert a drill or screw bit into the Chuck (8). Securely tighten.
Turn the chuck counterclockwise to open, and clockwise to close while holding on to
the chuck sleeve. Use 3/8 inch bits or smaller to avoid damage to gears and motor.
2.
Set the desired drill torque by turning the Torque Selector to setting 1 to 6.
The higher the number, the more the torque. Use # 6 for drilling, and the others for
driving. Do this when the drill if off.
3.
Set the desired drill rotation by pressing the Rotation Switch (7) for drilling or driving;
Press Reverse for removing screws. Press Forward for drilling. Do this when the drill is
off.
4.
Press the Trigger Switch (5) in to turn the drill on.
The harder you press, the faster the rotation.
Chuck (8)
Torque Selector
Install saw blade. Prepare and secure the material to be cut before turning on saw. Battery
should have a full charge before using saw. Refer to illustrations that follow. Remove
battery before making any adjustments.
Warning: Do not hold tool by the handle while making adjustments as your fingers may
touch the Switch and Safe buttons and start the saw.
Installing Cutting Blade
1.
Remove battery.
Disregard these steps if the saw blade is already installed.
2.
Press on the stop button (17A) located on top of the saw to keep the saw blade from
moving while turning the nut bolt.
3.
Using the hex key (48A), loosen and remove nut bolt (1A) and washer (2A).
4.
Rotate movable guard (8A) clockwise to allow entry of blade.
SKU 40056
40056 combo pack.p65
5
Drill Operation
Rotation Switch (7)
Trigger Switch (5)
Circular Saw Operation
The item numbers (in brackets)
can be found on the Drill
Assembly and Drill Parts List.
Page 5
10/10/03, 10:11 AM
Advertisement
Table of Contents
