Identifying Correctly Sharpened Drill Bits - Drill Master X2 User Manual

Note:
Use just enough pressure to keep the Cam against the Cam
Pin. Let the machine do the sharpening.

Identifying Correctly Sharpened Drill Bits

(and what to do with those that aren't!)
Cutting
Heel
Chisel
Edge
Problem
The Chisel Edge is
ground flat.
16
Turn clockwise to sharpen.
Making sure that the Chuck rests
firmly against the Cam Pin, turn the
Chuck from white line to white line in
a smooth and even motion. For best
results, sharpen until there is no more
grinding noise, allowing the machine
to complete its sharpening cycle.
Correctly Sharpened Bits
The entire surface from the Cutting
Point
Edge to the Heel will have a finely
ground surface without ridges or in-
dentations. The Heel will always be
lower than the Cutting Edge (positive
relief ).
Cause
Alignment Fingers did not position
the drill bit properly in the aligning
process.
Solution
Realign the drill bit carefully by
following steps 1 through 4 under
Aligning the Drill Bit.
www.drilldoctor.com