Table of Contents
Advertisement
3.
ASSEMBLY AND WIRING
Transmitter is delivered along with a power supply (See below). The manufacturer
provides necessary wiring linking a power supply with the transmitter, and
described procedures relate to wiring of a transmitter printed circuit board.
Switch power off to perform any connection.
3.1.
LX2N TRANSMITTER
a) Connections of wires shall be made with due care to prevent any faults or dead
shorts. Places of connections shall be protected against weather conditions.
a) According to the above figure terminals of transmitter shall be connected to:
Terminal
T1 – R1
GND
IN1, IN2
LX2N_Manual_en-1.11i66
Figure 2. LX2N Transmitter with LX-ZAS
Connection description
Connection to alarm control panel phone communicator
Device ground, common for other input and output
Signal inputs. Possible connection of detectors contacts or
alarm control panel outputs. GND terminal is common for
Page 8 / 56
Advertisement
Table of Contents
