Conditions; Additional Conditions; Advanced Outputs Control - EBS LX2N Installation And Programming Manual

Table of Contents

Advertisement

7.11.1.2. Conditions

Defines conditions for activating both of outputs. User can set following conditions:
No GSM signal (immediately after detection);
o
Detection of incoming call from defined telephone number;
o
Dependent on state transitions from non-active to active of one of the inputs.
o
Outputs can be also activated by internal watchdog, which can be configured
in "Link control" group.

7.11.1.3. Additional conditions

If option "Dependent on state transitions from non-active to active of one of the
inputs" is chosen, we might configure additional conditions for output activations:
Never: input disturbance does not cause operation of sabotage output,
o
No network: input disturbance causes actuation of sabotage output if sending
o
of information to server is impossible.
Always: every input disturbance causes actuation of sabotage output.
o
Available network: input disturbance causes actuation of sabotage output if
o
sending of information to server is possible.
Note: Output may be controlled by SMS commands.

7.11.2. Advanced outputs control

The user is able to determine an alternative course of action to go over basic
outputs configuration function described in 0 . In the "Advanced outputs control"
you may define separately the behavior of each of the outputs, depending on events
taking place. "Advanced outputs control" differs from the existing basic "Outputs
configuration" by:
o it is possible not only to turn on but also to turn off the output
o output can be activated temporarily for specified amount of time
o there is a complete list of events for which you can define the behavior of the
output
Note: where possible, use either the basic configuration of outputs (0 )
or
with
In particular, the basic configuration of existing options: "No GSM signal
(immediately after detection)" and "Dependent on state transitions from non-
active to active of one of the inputs" should not be used with their replacements
"[Off] GSM" and "[On] Input x".
LX2N_Manual_en-1.11i66
an
"Advanced
outputs
control"!
Page 31 / 56

Advertisement

Table of Contents
loading

Table of Contents