Table of Contents
Advertisement
4.
QUICK START PROCEDURE
NOTE :
Do not insert SIM card before the first programming of transmitter as it
may block the card if PIN code is required for the card.
This chapter is purposed for users that possess experience regarding GPRS
data transmission systems and who work with OSM.2007 receiver for
monitoring system. Other users shall skip this chapter and go to chapter 5
of this Manual.
As many users possess protected facilities spread at vast locations, local
programming of
programming cable).
Two phases comprise programming in this option:
a) sending to transmitter of main parameters (with SMS) that enable connection
to receiver (OSM.2007 system).
b) full configuration of device with remote programming (GPRS transmitter
configurator and OSM. 2007).
Quick start procedure:
a) insert into device SIM card with PIN code 1111.
b) connect power supply for module,
c) send to SIM card number with SMS parameters related to connection of
device to receiver (OSM. 2007)
d) waiting for moment, when device indicates connection to OSM.2007
Note: Connection to receiver is possible if the device was registered into it.
Registration procedure has been described in OSM.2007 Operation Manual.
e) complete, remote programming with GPRS transmitter configurator.
SMS text message shall provide the following information:
<transmitter's service code>█SERVER=<server address>█PORT=<server
APN=<access point name>█UN=<user ID
PW=<user password>
Where:
█: space (every parameter shall be separated with space – blank character)
<transmitter's service
<server
address>: address of communication server purposed for collection of
transmitter signals e.g. 89.123.115.8 In case address is provided as domain e.g.
block.autostrada.com, SMS message shall include DNS1 parameter (address of
main DNS server)
<server
port>: Number of port in server that receives messages from a device
<access point
name>: defines access point name to GSM network.
If private network is used, SMS message shall provide the following parameters:
UN=<user ID number>
LX2N_Manual_en-1.11i66
transmitter is not always available (with PC computer and
code>: factory settings -1111
and
PW=<user
number>█
password>.
port>█
Page 12 / 56
Advertisement
Table of Contents
