Table of Contents
Advertisement
8.
DEVICE PROGRAMMING
Programming
of
configuration program described in chapter 5. To program the device establish
connection with a device.
Depending on connection mode there are two ways for programming.
8.1.
LOCAL PROGRAMING
To program a device locally follow the procedure:
a) Connect PROG joint (on printed circuit) with COM computer port by way of
service wire, defined in option -> RS-232.
b) Connect power supply to terminals V+ and GND. After connection and detection
of programming wire a module shall signal this with LED diodes: a green one
shall flash and red one shall flicker.
c) Launch software and define device options (description is in chapter 6 of this
Manual). Provide right PIN code for SIM card.
d) Save settings into memory of device. Saving course is displayed in special
window.
e) After saving disconnect power supply and disassembly service wire.
f) Insert SIM card. Connect module wiring pursuant to guidelines from chapter 4.
Turn power supply on.
g) The device is ready to transmit data.
8.2.
REMOTE PROGRAMMING
Remote programming of device is possible if:
user uses GPRS transmitter configurator and GSM modem connected to PC
user uses OSM.2007 monitoring system receiver.
In first case remote programming is possible on CSD channel and its procedure is
analogous to local programming, remembering that "Modem GSM" shall be selected
from connection options (See chapter 6.3.5.2-CSD Link).
Note: Remote configuration with use of CSD canal is possible only if transmission
of CSD data is active both for SIM card inserted in the device, and for SIM card
installed in GSM modem.
In second case according to description in chapter 6.3.5.2 –GPRS Link, it is required
to define remote link on grounds of OSM.2007 parameters. As OSM.2007 collects
LX2N_Manual_en-1.11i66
device
is
possible
with
"GPRS
transmitters
configurator"
Page 50 / 56
Advertisement
Table of Contents
