Pit-Stop Mode 11; Xl Pit-Stop Mode 11; Manual Transmission Starting 11 - Excalibur AL-1870-3DB Operation Manual

PIT-STOP MODE
This feature allows you to leave your engine running for making quick errands To use
this feature, have the engine running normally from the ignition switch and your foot off the
brake pedal. Press the Valet Switch twice; the parking lights will flash and the ignitions will
turn on Turn the key off and the engine will remain running for the programmed run time
Run time extender can be used in this mode
XL PIT-STOP MODE
This feature allows you to leave your engine running for an extended period of time To
use this feature, have the engine running normally from the ignition switch and your foot
off the brake pedal. Press the Valet Switch 6 times; the parking lights will flash and the
ignitions will turn on Turn the key off and the engine will remain running for 12hrs Run
time extender can be used in this mode allowing a run time up to 24hrs This is ideal for
commercial refrigeration trucks, cleaning vans, vehicles w/ PTO, etc
MANUAL TRANSMISSION STARTING
Remote starting with a manual transmission requires that you ensure the gear selector
is in NEUTRAL There are 2 available methods
METHOD #1 - 3D MOTION SENSOR:
This system is equipped with a 3D motion sensor built into the antenna Whenever remote
start is activated, the sensor is monitored for vehicle movement If the vehicle moves just
a few inches when the engine is cranking, it will instantly turn the engine off This safety
feature allows you to enjoy remote start without performing reservation mode as described
below
METHOD #2 - RESERVATION MODE:
For extra safety, installer feature #11 can be turned on which requires you to perform a
setup procedure that ensures the transmission was left in neutral when you park your
vehicle This must be performed each time you leave your vehicle to use remote start
later To do so, follow these steps:
1) With the engine running via the ignition switch, hold the brake pedal, apply the parking
brake, then release the brake pedal
2) Use the transmitter as if you were activating remote start (default: press START twice)
The status light will start to flash slow.
3) Turn off the ignition key and exit the vehicle, the engine will continue running
4) Press LOCK on the transmitter The engine will shut down (unless turbo timer is on)
and the status light will flash every 2 seconds (ready to be remote started).
NOTE: Manual transmission starting is canceled if you enter the vehicle after
performing the setup procedure.
Other Remote Start Features (cont'd)
11