Manual Transmission Starting; Security System Features (Optional); Last Door Arming; Automatic Rearming - Excalibur RS-360-EDP Operation Manual

mANUAL TRANSmISSION STARTING

Remote starting with a manual transmission requires a different installation method and
installer feature #11 must be turned on� Also, a setup procedure that ensures the transmission
was left in neutral must be performed each time you leave your vehicle and intend to use remote
start later� Perform these steps:
1) With the engine running, hold the brake pedal, apply the parking brake, release the brake
pedal�
2) Use the transmitter as if you were activating remote start (default: press START twice)� The
status light will start to flash slow.
3) Turn off the ignition key and exit the vehicle�
4) Press LOCK on the transmitter� The engine will shut down (unless turbo timer is on) and the
status light will flash every 2 seconds to indicate it is ready to be remote started.
NOTE: manual transmission starting is canceled if you enter the vehicle after performing
the setup procedure.
This system is equipped with our exclusive VIRTUAL ALARM technology. The se-
curity functions described in this section are available as a simple upgrade from your
dealer. It may require a plug-in module and some additional configuration, but will
greatly enhance your system's capabilities and add theft deterrence to your vehicle.
TALK TO YOUR DEALER TODAY ABOUT UPGRADING!

LAST DOOR ARmING

This system can be configured to arm automatically when all the vehicle's doors are closed
(see user feature #9)� When enabled, the siren/horn will chirp once when all of the doors are
closed. It will start a 30 second countdown (indicated by a fast flashing status light) after which,
the system will lock and/or arm� The 30 second arming delay will pause while a point of entry is
open. Turning ON the ignition key will cancel the arming sequence until the key is turned off and
the doors are all closed once again�
NOTE: Installer feature #13 must be on and the system must be wired for security functions.

AUTOmATIC REARmING

This automatically rearms the alarm if the system is disarmed from the remote� (see user
feature #10)� When disarmed by remote, the system will start a 90 second countdown (fast
flashing status light) to arm the system. This is useful if the controller accidentally disarms the
system when it's kept in a purse or pocket where other items could potentially press the buttons�
ENHANCED AUTO REARM allows you to cancel the countdown by pressing UNLOCK a second
time within 5 seconds of the first press to disarm the alarm.
NOTE: Installer feature #13 must be on and the system must be wired for security functions

PRE-wARN DETECTION

EXTERNAL SENSORS ARE OPTIONAL UPGRADES. TALK TO YOUR DEALER.
The optional impact sensor is designed, in addition to detecting a full impact, to warn
away potential violators when it detects a light impact to the vehicle� The system will
respond by chirping the siren/horn 3 times and locking the doors� This is very useful
when an intruder attempts to unlock the door with "slim jim" types of devices�
Other Remote Start Features (cont'd)

Security System Features (OPTIONAL)

7