Turbo Timer Feature; Pit-Stop Feature; Manual Transmission Starting; Security System Features - Excalibur AL-1650-EDPB Operation Manual

method 2 - with The Controller (Low Volt + Low Temp - 15 Degrees Only)
• Within 5 seconds of pressing LOCK, press the START button. You will get one chirp and the
2-way controller will alternate between "ARM" and "RS AUTO"�
nOTE: When low temp start mode is activated, low voltage start is also activated� These features
will operate once every two hours until the ignition key is turned "On"�

TURBO TimER FEATURE

This is recommended for vehicles equipped with a turbocharger. It allows the engine to idle af-
ter driving to cool the turbo� When this Installer Programmable Feature (#4) is enabled, the system
will automatically keep the engine running as follows:
• With the engine running, hold the brake pedal and engage the parking brake.
When the brake pedal is released, the system will keep the engine running for the programmed
time (1, 2, or 3 minutes), and then automatically turn it off�
• The system may be locked while the engine is running. Turbo Timer can be prevented from
engaging, or "bypassed" if desired, by turning the engine off before engaging the parking brake�

PiT-STOP FEATURE

This feature allows you to leave your engine running for making quick errands. To use this fea-
ture, have the engine running normally from the ignition switch and your foot off the brake pedal�
Press the Valet Switch twice; the parking lights will flash and the horn chirps 5 times. Turn the key
off and the engine will remain running for the programmed run time�

mAnUAL TRAnSmiSSiOn STARTinG

Remote starting with a manual transmission requires a different installation method and
installer feature #5 must be turned on� Also, a setup procedure that ensures the transmission was
left in neutral must be performed each time you leave your vehicle and intend to use remote start
later� Perform these steps:
1) With the engine running, hold the brake pedal, apply the parking brake, then release the brake
pedal�
2) Use the transmitter as if you were activating remote start (default: press START twice)� The
green status light will start to flash slow.
3) Turn off the ignition key and exit the vehicle�
4) Press LOCK on the transmitter� The engine will shut down (unless turbo timer is on) and the
status light will flash green every 2 seconds to indicate it is ready to be remote started.
nOTE: manual transmission starting is canceled if you enter the vehicle after performing
the setup procedure.

LAST DOOR ARminG

This system can be configured to arm automatically when all the vehicle's doors are closed
(see user feature #2)� When this feature is utilized, the siren/horn will chirp once when all of the
doors are closed. At that point, it will start a 30 second countdown (indicated by a fast flashing sta-
tus light). After 30 seconds, the system will arm (and lock the doors if configured to do so). During
the 30 second arming delay, if a point of entry is opened, the countdown will pause until all entry
points are closed again. Turning ON the ignition key will cancel the last door arming sequence
until the key is turned off and the doors are all closed once again�

AUTOmATiC REARminG

This automatically rearms the alarm if the system is disarmed from the remote� (see user
feature #3). When disarmed by remote, the system will start a 90 second countdown (fast flash-
ing status light) to arm the system� This is useful if the controller may accidentally disarms the
system when it's kept in a purse or pocket where other items could potentially press the buttons�
EnhAnCED AUTO REARM allows you to cancel the countdown by pressing UnLOCK a second
time within 5 seconds of the first press to disarm the alarm.
Other Remote Start Features (cont'd)

Security System Features

7