Table of Contents
Advertisement
Other Remote Start Features (cont'd)
PIT-STOP FEATuRE
This feature allows you to leave your engine running for making quick errands� To
use this feature, have the engine running normally from the ignition switch and your
foot off the brake pedal. Press the Valet Switch twice; the parking lights will flash and
the horn chirps 5 times� Turn the key off and the engine will remain running for the
programmed run time�
MAnuAL TRAnSMISSIOn STARTInG
Remote starting with a manual transmission requires a different installation method
and installer feature #5 must be turned on� Also, a setup procedure that ensures the
transmission was left in neutral must be performed each time you leave your vehicle
and intend to use remote start later� Perform these steps:
1) With the engine running, hold the brake pedal, apply the parking brake, then
release the brake pedal�
2) Use the transmitter as if you were activating remote start (default: press START
twice). The green status light will start to flash slow.
3) Turn off the ignition key and exit the vehicle�
4) Press LOCK on the transmitter� The engine will shut down (unless turbo timer is
on) and the status light will flash green every 2 seconds to indicate it is ready to be
remote started�
nOTE: Manual transmission starting is canceled if you enter the vehicle after
performing the setup procedure.
Security System Features
LAST DOOR ARMInG
This system can be configured to arm automatically when all the vehicle's doors
are closed (see user feature #2). When this feature is utilized, the siren/horn will chirp
once when all of the doors are closed� At that point, it will start a 30 second count-
down (indicated by a fast flashing status light). After 30 seconds, the system will arm
(and lock the doors if configured to do so). During the 30 second arming delay, if a
point of entry is opened, the countdown will pause until all entry points are closed
again� Turning ON the ignition key will cancel the last door arming sequence until the
key is turned off and the doors are all closed once again�
AuTOMATIC REARMInG
This system can be configured to rearm automatically whenever the system is
disarmed (see user feature #3). When this feature is utilized, the system will start a
90 second (indicated by a fast flashing status light) countdown to arm the system
after using the controller to disarm/unlock the system� This is very useful for situations
when the controller may accidentally disarm/unlock the system� For example, if it's
kept in a purse or pocket where other items could potentially press the buttons�
PRE-WARn DETECTIOn
This system's impact sensor is designed, in addition to detecting a full impact, will
warn away potential violators when it detects a light impact to the vehicle� The system
will respond by chirping the siren/horn 3 times and locking the doors� This is very use-
ful when an intruder attempts to unlock the door with "slim jim" types of devices�
10
Advertisement
Table of Contents
