Table of Contents
Advertisement
Pronar T683
5.11 INSTALLATION AND DISASSEMBLY OF THE FRAME
AND TARPAULIN COVER
Tarpaulin cover can only be used together with the frame. The assembly of wall extensions
should be carried out with the use of appropriate platforms, ladders, ramps or other stable
raised surfaces. Particular care should be taken, holding onto the trailer with one hand. Work
should be done with the help of another person.
The frame structure comprises front apex (1) – figure (5.15), rear apex (2), centre apex (3),
ridge pipe (4), and two rim pipes (5).
Assembly of frame and tarpaulin
attach front apex (1) to the front wall extension,
attach rear apex (2) to the rear wall extension,
attach centre apex (3) to the middle stakes,
screw down ridge pipe (4),
screw down two rim pipes (5),
place tarpaulin cover (7) so that it rests on the limiters,
secure the tarpaulin cover with grabs (13) riveted to the right wall of load box,
unroll tarpaulin cover using rolling beam (6). Install tensioners (8) on the beam
and, using hooks (11), attach tensioners to catches (12) located on the left
side of the trailer.
tighten tarpaulin cover and secure the front and rear part of the tarpaulin cover
to catches (16) using expanders (14).
Disassembly of the frame and tarpaulin cover should be performed in reverse order.
DANGER
Assembly and disassembly of the frame should be carried out with the use of appropriate
platforms, ladders or when standing on a ramp. These tools must be in good condition to
fully protect the persons working on them against falling. Work should be performed by at
least two persons. Exercise particular caution.
5.38
SECTION 5
Advertisement
Table of Contents
