Table of Contents
Advertisement
Pronar T683
While carrying out maintenance and repair work, which involves the risk of an oil leak, this
work should take place on an oil resistant floor or surface. In the event of oil leaking into the
environment, first of all contain the source of the leak, and then collect the leaked oil using
available means. Remaining oil should be collected using sorbents, or by mixing the oil with
sand, sawdust or other absorbent materials. The oil pollution, once gathered up, should be
kept in a sealed, marked, hydrocarbon resistant container. The container should be kept
away from heat sources, flammable materials and food.
Oil, which has been used up or is unsuitable for further use owing to a loss of its properties
should be stored in its original packaging in the conditions described above. Waste oil should
be taken to the appropriate facility dealing with the re-use of this type of waste. Waste code:
13 01 10. Detailed information concerning hydraulic oil may be found on the product's
Material Safety Data Sheet.
IMPORTANT
Waste oil should only be taken to the appropriate facility dealing with the re-use of this
type of waste. Do NOT throw or pour oil into sewerage or water tanks.
1.7 WITHDRAWAL FROM USE
In the event of decision by the user to withdraw the trailer from use, comply with the
regulations in force in the given country concerning withdrawal from use and recycling of
machines withdrawn from use. Before commencing dismantling, totally remove the oil from
the hydraulic system and reduce air pressure completely in the pneumatic brake system (e.g.
using air tank drain valve).
Worn out or damaged parts that cannot be reclaimed should be taken to a collection point for
recyclable raw materials. Hydraulic oil should be taken to the appropriate facility dealing with
the re-use of this type of waste.
During dismantling personal protection equipment shall be used i.e. protective clothing,
boots, gloves and protective goggles etc.
1.14
SECTION 1
Advertisement
Table of Contents
