Table of Contents
Advertisement
MX-4000W
Physical Installation-Wall Mounting
To install MX-4000W ATM, perform the following steps (referring to the picture in the following pages),
NOTE:
Prior to the installation, you will need to prepare the hardware (e.g. shank) to mount the
mounting frame bracket.
can not supply the hardware you may require. The maximum shank diameter of the mounting
hardware is 1/5 inch.
It is the owner's responsibility to ensure that the machine is anchored securely. Personal
injury and equipment damage can occur if the machine is not properly secured.
1. Unlock the key lock and press the Push_End button to open the front door.
2. Take out the cash dispenser unit by pulling it out and separate the mounting frame bracket.
(Unfasten the screws, 6ea)
3. Attach the mounting frame bracket separated in the previous step on the wall using the hardware
prepared in advance. It is recommended that the bottom of the mounting frame bracket is 1m
(39.37inch) off the floor to help meet ADA guidelines.
4. Hang the ATM on the mounting frame bracket and fasten the screws (6ea) unfastened in the step of
2.
5. To take the power cable and LAN cable out of the ATM, separate the bracket on the bottom inside
the ATM. After taking them out, place the bracket on its original position.
Due to the variety of walls and their composition, Nautilus Hyosung
6- 7
6. Installation
Advertisement
Table of Contents
