HYOSUNG MX-4000W Operator's Manual page 151

MX-4000W 5. Operator Function
5.8.8.4 SET THE TYPE OF MACHINE
After you select CLEAR ALL or CLEAR SETTING button, the screen will be changed into the screen
as same as below.
However, MX4000W, NH1800SE buttons will show up only if the ATM is NH1800SE or MX4000W. So
if you are in doing some manipulations in NH2700 or NH2700T, there are no buttons as above. This is
because only in NH1800SE and MX4000W, there is necessity to select the type of machine. It means
that S/W itself can`t distinguish NH1800SE from MX4000W automatically. So before clearing NVRAM
you must select the type of machine.
After selecting the type of machine, just push APPLY AND CLEAR button. And then the screen would
be changed into one as same as below to confirm your wish of clearing data in NVRAM.
5- 113