Boss Snowplow MSC08042C Owner's Manual page 93

Troubleshooting Guide
PROBLEM
19. Plow does not clean-up
snow from low areas.
20. Oil running out of fill cap of
hydraulic pump.
21. Pump chatters when
raising plow or extending
wing(s).
22. SmartHitch2™ will not
attach plow.
DIAGNOSTIC CHECK
UP/DOWN switch not in
FLOAT position.
Power light tower down. Do
not pull the tower down.
Plowing on steeply inclined
terrain.
Pump reservoir over filled.
Hitting snowbanks too hard.
Hydraulic fluid low.
Make sure key is on and
controller is in FLOAT.
Make sure controller is
staying in the Float position
Check valve block and
TM
SmartHitch2 switch for
proper connections.
94
RESULT
Place switch in FLOAT
position.
Follow the dismounting
instructions in this manual.
Avoid too steeply sloped
areas.
Reservoir should be filled to
¾" from top.
Do not plow recklessly.
Add hydraulic fluid. Reservoir
should be filled to ¾" from top.
Turn key on and put controller
in FLOAT.
If controller comes out of Float
when using the SmartHitch2
switch, replace the controller.
Refer to manifold wiring
diagram located within this
manual or on hydraulic pump.
TM