Boss Snowplow MSC08042C Owner's Manual page 92

Table of Contents

Advertisement

Troubleshooting Guide
PROBLEM
14. Turn signals flash at a
rapid rate.
15. No high beam indicator or
does not function properly.
16. Blade digs into the ground
in the V-position.
17. Blade does not lay flat on
ground in scoop position.
18. Blade trips too easily.
DIAGNOSTIC CHECK
Check relays for corrosion
and function.
Check headlight adapters.
Check headlight adapters.
Check Bumper Stop
Location.
Push beam installed too
high.
Check Bumper Stop
Location.
Push beam installed too low.
Check trip spring adjustment.
Check Push Beam height.
93
RESULT
Relays should click when
energized.
Verify proper headlight
adapters are being used and
are correctly installed.
Verify proper headlight
adapters are being used and
are correctly installed.
Adjust Stop as noted in this
manual.
Lower the push beam.
Adjust Stop as noted in this
manual.
Raise the push beam. If push
beam is at highest setting,
Adjust the Bumper Stop
further into the center section.
Tighten springs. Replace
springs if damaged.
Adjust to proper height.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the MSC08042C and is the answer not in the manual?

This manual is also suitable for:

Msc08063b

Table of Contents