Taking Your Plow Out Of Storage - Boss Snowplow MSC08042C Owner's Manual

Taking the Power-V Plow out of Storage
1. Before you attach your plow, check for cracked welds and check all fasteners for tightness.
Recommended Bolt Torque located in this manual.
2. Go over all the hydraulic hoses looking for cracks and leaks.
3. Change your snowplow hydraulic fluid using BOSS Snowplow High Performance Hydraulic Fluid.
Hydraulic Power Unit Fill Procedure located in this manual.
4. Check your cutting edge for excessive wear.
5. Check your plow shoes for wear (If installed).
6. Tighten your trip return springs and your blade return springs.
7. Grease the coupler spring pins.
8. Grease the vertical hinge pin bushings.
9. Attach the plow to the truck and extend both blades into the scoop-position.
10. Check hydraulic cylinders for leaks and check rods for corrosion or pitting.
11. Touch-up any rust spots or chipped paint.
12. Apply dielectric grease to the electrical plugs (lights, valve assembly, pump, pump solenoid, and battery).
13. Align your plow lights once your snowplow is attached and in the raised position.
Procedure located in this manual.
23
See
See
See Headlight Aiming