Boss Snowplow MSC08042C Owner's Manual page 18

Power-V Controllers
Swivel Mount Kit
Mounting Instructions
SWIVEL
TM
Figure 9. SmartTouch2
1. Remove the Swivel Mount and Tab from the
MSC05058 Swivel Mount Kit.
2. Use the enclosed alcohol wipe to clean a spot
on the vehicle interior where you want to place
TM
the SmartTouch2
immediately with a cloth or paper towel.
3. Do not apply when the surface temperatures
are lower than +60˚F (Working temperature
range of the adhesive is -40˚F to +200˚F).
Control
TAB
Mounting Hardware G10311
Control. Wipe dry
4. Peel off the paper backing on one side of the
adhesive and apply to Swivel Mount. Apply
maximum pressure to all areas.
5. Apply the Swivel Mount onto the spot of the
interior that was just cleaned. (MAKE SURE
IT IS IN THE CORRECT PLACE) Once it is
placed it cannot be removed without
destroying the adhesive.
6. Clean the back of the SmartTouch2
with the alcohol wipe.
7. Peel off adhesive backing of tape, apply to
Tab, and press firmly.
8. Remove remaining backing and apply the
Tab to the back of the SmartTouch2
Control. Apply pressure for 30 seconds.
19
TM
Control
TM