Using Maintenance Mode - Epson Stylus Pro 11880 User Manual

Maintaining and Transporting the Printer
5. Press to save the setting.

Using Maintenance Mode

Maintenance mode allows you to make special settings and perform
maintenance procedures that may be needed occasionally. You can use
maintenance mode to do the following:
Change the language or units of measurements used on the printer's
•
control panel menus
Change the default pressure setting for the automatic cutter
•
Run a "super strong" cleaning cycle
•
Enable power on roll paper feed
•
Return all of the printer's control panel settings to their default values
•
Follow these steps to use maintenance mode:
1. Make sure the printer is turned off.
2. Press and hold the
hold it until the printer turns on and displays
3. Use the d and u buttons to select the settings described below. If you
need to back up to the previous menu level, press l.
To change the language on the LCD display, press d to select
•
LANGUAGE
want, then press
mode and returns to normal operation.
To change the units of measurement, press d to select
•
press r. Press d to switch from
to select it.
To change the default cutting pressure, press d to select
•
, then press r to display
PRESSURE
pressure, or the u button to increase it (in 1% increments). Press
to select the setting you want.
5-131
Pause button, then press the P Power button and
, then press r. Press d until you see the language you
to select it. The printer exits maintenance
METER
MAINTENANCE.
UNIT
to , then press
FEET/INCH
CUT
. Press d to decrease the
100%
| 131
, then