Epson Stylus Pro 11880 User Manual page 27

4. Plug the cable into the connector on the back of the printer as shown
below, then tighten the screws on both sides of the connector.
5. Attach the movable unit to the left side of the support bar. Turn the lock
lever to the left to release it.
6. While holding the movable unit, attach the movable unit stopper as
shown. Snap the two tabs on the stopper into the movable unit. Use the
two screws to secure the movable unit to the support bar.
7. Attach the left paper stop (labeled L) to the movable unit by pinching
the knob.
1-27
Setting Up the Printer | 27