JRC JMA-9123-7XA Instruction Manual page 194

>
JMA-9100 Instruction Manual 3.BASIC OPERATION
2) Left-click the
The Waypoint inserting mode is selected.
3) On the radar display, put the cursor on the section line into
which a Waypoint is to be inserted, and left-click.
The section is specified, the cursor becomes a cross cursor mark, and the cross cursor mark is
connected to the previous and following Waypoints by a rubber band.
On the radar display, put the cursor on the location at which a
4)
Waypoint is to be inserted, and left-click.
The coordinates of the new Waypoint are specified, and the new Waypoint is connected to
the previous and following Waypoints by a line.
To insert another Waypoint, repeat procedures 3 and 4.
5)
6) To finish inserting a Waypoint, left-click the
button.
The Waypoint inserting mode will be cancelled.
(Example)
001
Waypoint is inserted into this section .
>
3.7 USE ROUTE FUNCTION
6. Insert
090T
10.0kn
3－ 74
button.
6. Insert
Rubber band
090T
001
10.0kn
Waypoint is inserted into this section .