JRC JMA-9123-7XA Instruction Manual page 139

3.3.4.3 Increasing or decreasing a numeric value
Procedures
On the numeric value input screen, sequentially left-click the
1)
software button
enter a desired numeric value.
For example, when adjusting 123.0° to 123.4° for a bearing value, sequentially left-click the
software number keys as shown below.
→
＋
Make sure that the entered value is correct, and left-click the
2)
ENT
The set value is reflected to the operating state.
3) To stop entering a value, right-click the
Alternatively, left-click the
The numeric value input screen will close without reflecting the set value to the operating
state.
3.3.4.4 Latitude/longitude input screen
Numeric button
- button (south latitude /
west longitude)
CLR button
JMA-9100 Instruction Manual
or
＋
→ →
＋ ＋ ＋
button.
3－ 19
> >
3.BASIC OPERATION 3.3 OPERATION PROCEDURES
located on the radar screen, and
－
ENT
button.
CLR
Entered latitude /
longitude
+ button (north latitude /
east longitude )
ENT button
button.
3