Removing The High Pressure Switch, High Pressure Sensor And Low Pressure Sensor; Removing The High Pressure Switch (Psh1, Psh2) - Hitachi FSXN Series Service Manual

10 Servicing
10.13 Removing the high pressure switch, high pressure sensor and low pressure
sensor
D A N G E R
• Turn OFF all the power source switches.
N O T E
• For servicing use the following tools:
- Pliers.
- Phillips screw driver.
1 Remove the front service cover as described in the procedure
2 The high pressure switch -A- (PSH1) and -B- (PSH2), the high pressure sensor -C- (Pd) and the low pressure sensor
-D- (Ps) are fixed in the position shown in the figure.
RAS - (8-12) FSXN
A
D
318
SMGB0065 rev. 1 - 12/2010
- Adjustable wrench or spanner.
- Burner.
C
A
Removing the front service
RAS - (14-18) FSXN
B
D
cover, see on page 292.
C