Removing The Ambient Temperature Thermistor - Hitachi FSXN Series Service Manual

10 Servicing

10.15 Removing the ambient temperature thermistor

1 Remove the front service cover as described in the procedure
2 Remove the cover of the electrical box as described in the procedures
(8-12)FSXN, see on page 295 and
3 Remove the upper cover as described in the procedure
N O T E
When removing the upper cover take care not to damage the shroud.
4 Remove the clamps that fix the wiring.
5 To fit the ambient temperature thermistor, carry out this procedure in reverse order.
N O T E
If the upper cover is not correctly fixed, it may cause vibrations in the upper cover when the outdoor unit fan
is running. Check the upper cover carefully after fitting it.
322
SMGB0065 rev. 1 - 12/2010
Removing the electrical box for
To Electrical Box
Thermistor Position
Ta ( Thermistor for
Ambient Temp.)
Thermistor Holder
Air Intake Grille
(Side Cover)
Removing the front service
Removing the electrical box for RAS-
RAS-(14-18)FSXN, see on page 295.
Removing the upper cover, see on page 293.
cover, see on page 292.