Trouble Shooting - DT SWISS F 535 ONE Technical Manual

3. TROUBLE SHOOTING

Issue
The fork is not responding
properly.
The fork bottoms out on
moderate bumps.
The full travel of the fork
cannot be used.
The fork does not rebound
completely and hardens on
fast repetitive bumps.
The fork rebounds too
fast, the front wheel loses
contact to the ground after
bumps or it slides in turns.
The lockout does not work
well.
If the problem cannot be solved, contact a DT Swiss service center!
6
Reason
The bedding-in time is not over.
The air pressure is too high.
The fork needs a small service.
The air pressure is too low.
The air pressure is too high.
Wrong measurement of the
travel. Some forks do not
use the full stroke of the
stanchions.
Too much rebound damping.
Not enough rebound damping.
Leaks inside the cartridge.
Remote Lockout: The lockout
cable is not tensioned correctly.
Solution
Continue riding (bedding-in time is about
20 operating hours).
Decrease the air pressure controlled using
a suitable shock pump.
Carry out a small service (see ) yourself
or by your dealer or a DT Swiss service
center.
Increase the air pressure controlled using
a suitable shock pump.
Reduce the air pressure.
Always measure the distance between
wiper seal and SAG O-ring.
Decrease rebound damping.
Increase rebound damping.
Contact your local dealer or the
responsible DT Swiss service center to
solve this problem.
Check the proper fixation and the tension
of the lockout cable.