DT SWISS F 535 ONE Technical Manual page 20

5.4 ASSEMBLING THE REMOTE CONTROL ELEMENTS
1. Turn the lockout shaft clockwise until stop (LOCK
mode).
2. Put on the dust seal.
3. Put on the spring and the limiter cap.
→ Both the spring and the limiter cap must be
placed in the bore next to the mark on the
damping unit.
4. Put on the spring.
The lower arm of the spring must be placed
inside the bore.
5. Put on the remote wheel.
The arm of the spring must be placed inside the
bore of the remote wheel.
6. Push down the remote wheel and screw on the
nut by hand as far as possible.
20