Trouble Shooting - DT SWISS D 232 Technical Manual

5. TROUBLE SHOOTING

Issue
seat post does not compress
or extend properly
seat post blocked / does not
release
14
Reason
dirty / too little grease
O-ring ("2. Overview" on
page 6 / No. 13) crushed /
defective
wiper seal of lock nut damaged
release piston jammed
cable tension too low
cable torn
cable unhooked from the
quickconnector
quickconnector damaged
lower seat tube cover damaged
connection of quickconnector
and actuating spoke loose
actuating spoke defective
release piston jammed
O-ring ("2. Overview" on
page 6 / No. 13) crushed /
defective
Solution
small service
details, see 6 on page 17
disassemble the seat post
completely, clean all parts.
replace guiding kit.
details, see 7 on page 24.
disassemble the seat post
completely, clean all parts.
replace slider tube nut
details, see 7 on page 24.
disassemble the seat post
completely, clean all parts.
replace latch system
details, see 7 on page 24.
increase tension of the cable
replace cable
dismount the seat post and attach
the cable
replace quickconnector
details, see 7 on page 24.
install new seat tube
details, see 7 on page 24.
clamp actuating spoke to
quickconnector.
details, see "Mounting the
Quickconnector" on page 34.
replace the actuating
details, see "Mounting the
Quickconnector" on page 34.
disassemble the seat post
completely, clean all parts.
replace latch system
details, see 7 on page 24.
disassemble the seat post
completely, clean all parts.
replace guiding kit.
details, see 7 on page 24.
kit.
kit.
kit.
cover.
spoke.
kit.