DT SWISS F 535 ONE Technical Manual page 33

7.7 CLOSING THE AIR CHAMBER
1. Clean the thread of the air chamber and the
thread of the air chamber cap.
2. Slightly grease the thread and O-ring.
3. Screw in the air chamber cap as far as possible
by hand.
4. Tighten the air chamber cap with a 15 mm
hexagon socket and a torque wrench to a torque
of 25 Nm.
7.8 INFLATING THE FORK
1. Inflate the fork (see user manual for detailed
information).
2. Screw on the valve cap according to the number
of volume spacers installed.
The kit contains various valve caps on which the
number of volume spacers is marked. If the valve
cap corresponding to the number of volume spacers
mounted is screwed on, it is possible later to see how
many volume spacers have been mounted without
opening the air chamber.
F 535 ONE Technical Manual V2021.11
25 Nm
33